We make "YOUR FUTURE"

Influence of the electromagnetic field on the silkworm pulse wave
Object
  To study the influence of electromagntic waves with a specific frequency on silkworms
Outline of experiment
Place a silkworm parallel to the electromagnetic field lines of the Helmholtz coil and observe the pulse wave changes.
The Helmholtz coil was subjected to an 5V(AC) and a freuency of 14Hz, 21Hz, and 50Hz, respectively.
These frequencies are based on the Schumann resonace that has been reported to have some effect on livng phenomenon.
Pulse waves were detected with a photo reflector and monitored through an amplification circuit
and Arduino with an IDE sketched (programmed) for pulse waves.
Sensor
Amplifier circuit
Arduino
monitoring

The sgnal is amplified
using an operational
amplifier,because
the electric signal
obtained from the sensor
is weak.
Input an electric
signal to "Arduino"
(one-board
microcomputer).
We can monitor
the output signal
from "Arduino" as
a waveform using
the sketch (programming)
created for pulse wave.
Examples
Before electromagnetic field generation
14Hz electromagnetic fieldis applied
21Hz electromagnetic fieldis applied
50Hz electromagnetic fieldis applied
After electromagnetic field generation
PAGE TOP